1. Clean your wall surface and flatten Wall Peel
2. Position the Mural
Tape the top two corners down with masking tape in desired location. Measure as necessary to be sure the mural is properly aligned.
3. "Hinge" the Panel
4. Peel the Decal
Peel the decal away from the backing paper exposing the sticky side of the decal. Be careful that it doesn’t stick to itself. Use scissors or a utility
knife to cut off the excess backing paper being careful not to harm the wall surface.
5. Apply the Mural
Starting at a center position near the hinge, use horizontal strokes with the squeegee to apply the exposed decal to the wall. Use gentle strokes
and even pressure to secure the entire section in this manner. Remove the remaining masking tape once the initial portion of the mural is secure and adhered correctly.
6. Complete the installation
Reach underneath the panel and gradually pull another portion of backing paper away from the decal. Use the same method to apply the exposed decal
using horizontal strokes with the squeegee tool. Continue to pull the paper away from the decal and apply with squeegee until complete. If an air bubble appears during the application, it may
be necessary to gently pull up a portion of the vinyl to release the air pocket. Re-apply using even pressure with squeegee until complete.
We make every effort to ensure your wall peel arrive with care. All orders are shipped in rolled tubes. Below is an example of a Canvas Print w/wrapped edges. We
strive to ensure all products ordered arrive undamaged regardless how the carrier delivers them. Our goal.